N536BS integrated TI CC1312R, PA and LNA chip, suitable for 169, 433M, 868MHz and 915M band.
Maximum output power is 33dBm. CC1312R module has the characteristics of low cost, low power consumption and small size. The module is designed with 4-layer board, with excellent impedance matching and anti-interference. The module is mainly for IoT, intelligent home, wireless meter reading, scientific research and medical treatment, and medium and long-distance wireless communication equipment. N536BS leads all pins out for secondary development.
Radio module CC1312R module up to 33dbm outpower and down to -112dbm sensitivity.
ISM Frequency supported by N536BS module
169M band: 160 MHz to 175 MHz (China)
433M band: 410 MHz to 510 MHz (China)
770M band: 770 MHz to 780 MHz (China)
868M band: 868 MHz to 870 MHz (China, EU, USA)
888 MHz to 889 MHz (Australia)
915M band: 902 MHz to 930 MHz (USA)
N536BS module Parameters
RF Interface
Parameter
Introduce
Frequency
169M, 433M, 868M, 915M, 1200MHz
Support ISM
Output Power
+33dBm
The maximum power 500mW
Sensitivity
-112dBm
50kbps
Symbol Rate
0.3-4000kbps
Software programming control
Deviation
+/-10kHz
Antenna interface
Distance
8000m
In clear and open environment, the antenna gain
is 3 dBi, the height above the ground is 2.5 meters,
and the air speed is 1.2 kbps.
Hardware parameters
Value
Remarks
Size
36 x 24 x 3mm
-
Antenna Interface
IPEX, stamp hole
-
Communication Interface
UART, SPI
Software programming
Package
SMD
-
Electrical Parameters
Minimum
Typical
Maximum
Remarks
Volt
1.8V
3.3V
3.9V
PA Volt
4.5V
5V
5.5V
Emission Current
1200mA
Instantaneous power consumption
Receiving Current
10mA
-
Sleep current
1uA
Software programming control
Working Temperature
-30℃
75℃
-
N536BS control Logic
N536BS Pinout Description
Pin Number
Function
Describe
1
GND
2
GND
3
VCCPA
PA power supply, 4.5V -- 5.5V, MAX current: 1200mA
4
VCCPA
PA power supply, 4.5V -- 5.5V, MAX current: 1200mA
Take the supporting base plate of Heyan technology as an example:
The bottom board of N536BS is T532AP, which integrates USB to serial chip, led, button, burning port and module card port. As shown in the figure:
N536BS secondary development method:
The CC1312R module is stuck on the backplane as shown in the figure, and the IPEX is connected with the antenna. The burning port is connected with xds110 according to the silk screen printing, and then online simulation can be carried out to test the performance of the module.
Module Programming
The schematic diagram of the module base plate can be obtained from our official website.
Please contact us for specific programming information or download it from TI official website www.ti.com.
